Click an LED to turn it round and see a diode block the current. Leave the resistor out and the LED burns out with a pop; join the rails with only wire and you get a short circuit. The readings show the current, every part’s voltage and the power, worked out with I = (V − VLED) ÷ R.
- How does a breadboard work?
- A breadboard is a plastic board full of holes with springy metal strips underneath. Each column of five holes is joined by one strip, so any legs pushed into the same column are connected. The long rails along the edges carry the + and − supply along the whole board, and the centre channel keeps the two halves apart.
- How do you use a breadboard for an LED circuit?
- Connect the battery to the + and − rails. Run a wire from the + rail to a column, then put a resistor (about 330 Ω for a 9 V battery) from that column to the next one, then the LED with its long leg towards +, then a wire back to the − rail. Each part must bridge two different columns.
- Why does an LED need a resistor?
- Once an LED reaches its forward voltage (about 2 V for red), it has very little resistance, so without a resistor the current shoots far past its 20–30 mA limit and it burns out. The resistor takes the remaining voltage and limits the current: I = (V − V_LED) ÷ R.
- How do you calculate the resistor for an LED?
- Subtract the LED’s forward voltage from the supply voltage and divide by the current you want. For a red LED (2.0 V) on a 9 V battery at 20 mA: R = (9 − 2) ÷ 0.02 = 350 Ω, so use the next standard value, 330 Ω or 390 Ω.
- What happens if an LED is put in backwards?
- Nothing lights and no current flows. An LED is a diode, so current can only pass from the anode (the longer leg, +) to the cathode (the shorter leg, next to the flat edge, −). At normal battery voltages a reversed LED is not damaged; just turn it round.
- What is a short circuit on a breadboard?
- A short circuit is a path from + to − with almost no resistance, for example a single wire across the rails. The current becomes very large (about 18 A from a 9 V battery in this model), so the battery and wires heat up quickly. Always have a component like a resistor, LED or buzzer in the loop.